Prefab Chimney ( Class A) - 10 in. Selkirk Prefabricated Chimney
The Rugged Stainless Steel Chimney That Makes Every Installation Simple, Fast And Sound.
Ultra-Temp Chimney, in 10"diameter, is ideal for venting natural and LP gas, #2 oil and open front wood burning appliances. The anchor plate allows the use of this chimney on masonry fireplaces.
Standard Stainless Steels are used for all insulated parts. The smooth stainless steel inner liner produces rapid stabilization of strong draft and heats fast to minimize condensation as waste gases are exhausted. The insulation in the pipe assures the highest possible inner wall temperature by preventing circulation of air between inner and outer chimney walls. This special insulation filling the space between the stainless steel walls is only 1" thick, yet it provides 17 times the insulating value of brick.
Selkirk’s chimney can be easily installed by one man. The chimney sections have threaded internal couplers that lock together in seconds with a 1/8 turn. Locking Bands are furnished with every pipe length to assure complete joint security. These systems come with a variety of components to meet every installation requirement.
Selkirk Ultra-Temp has been tested to 1700°F. These high temperature tests comply with Underwriter’s Laboratories Safety Standard for Factory-Built Chimneys, UL-103 Sixth Edition.
Limited Lifetime Warranty
Refer to manufacturer’s instructions for proper installation, usage, and maintenance.
Our Insulated Wall Thimble installs quickly and eliminates the need for using individual firestops. Interior plate has black matte finish. The round shielding acts as a radiation shield and provides the required 2" airspace clearance to combustibles. The two sections telescope to accommodate 6" to 11" wall thickness.
The Adjustable Pitched Ceiling Plate gives a finished appearance where the chimney passes through a sloped ceiling. Adjustable for various pitches. Black finish. (Class A) - 10" Selkirk Prefabricated Chimney.
The Insulated Chimney Tee may be used to start chimneys indoors or outdoors using a Wall Support Assembly or a masonry pier. A length of insulated chimney pipe is attached to the Tee Snout, using a Locking Band, to pass safely through combustible walls. An Insulated Tee Cap is included which can be removed from the bottom opening for inspection and cleanout. Useable height of 10” tee is 16 ¾”. Maximum height of chimney which can be supported by an Insulated Tee is 50 ft.
An ideal support assembly for freestanding fireplaces and open cathedral ceiling installations. Fits all roof pitches and requires only simple framing. Mounts easily on to top of roof through opening that allows 2" clearance. Maximum length of chimney which can be suspended below is 20' supported. Maximum total length is 30'.
The Roof Support Package (RSP) contains one 18" length of pipe, roof brackets and necessary hardware. The roof brackets and hardware may be purchased without the pipe section by ordering a Roof Support Kit (RSK). The brackets may be assembled to any standard pipe length at any desired height. Locking bands must be used at each pipe joint when installing either the RSP or RSK.
Made of flexible expanded 18-8 stainless steel mesh with diamond shaped openings
roughly 1/2 x 1 inch. Use to keep birds out when chimney is used for venting a gas appliance. Clean or replace whenever it becomes clogged with creosote
The Storm Collar is designed to fit on the round chimney pipe just above the roof flashing. The upper edge of the Storm Collar should be waterproofed with silicone sealer to prevent any water from leaking between the Storm Collar and chimney pipe.