3'' inside diameter pellet chimney section 6'' in length. This piece is useful when attached to bottom of a pellet chimney tee as it provides additional room for fly ash to settle.
A Wall Thimble must be used for all through-the-wall installations involving combustible construction. The thick wall thimble is designed to accommodate wall thicknesses for 6.5 ” to 11.5” and may be installed in direct contact with combustible framing, insulation and other materials. Dimension of plate at each end of thimble 12.5” square — diameter of thimble 7.5”.
Each flue gas carrying section of the pellet pipe is designed with a male and female end coupling. To join sections simply push mating ends together until the locking tabs engage, preventing them from being pulled apart.
Each flue gas carrying section of the pellet pipe is designed with a male and female end coupling. To join sections simply push mating ends together until the locking tabs engage, preventing them from being pulled apart.
Each flue gas carrying section of the pellet pipe is designed with a male and female end coupling. To join sections simply push mating ends together until the locking tabs engage, preventing them from being pulled apart.
Each flue gas carrying section of the pellet pipe is designed with a male and female end coupling. To join sections simply push mating ends together until the locking tabs engage, preventing them from being pulled apart.
Adjustable 90 degree elbows are available for use in accommodating unusual offsets and configurations. These optional accessories are designed with the same end couplings as the straight sections in order to facilitate their use anywhere in the system.
The vertical termination cap is intended for use in all installations in which the vent terminates in a vertical orientation. The cap provides necessary protection of the vent system from rain and other elements. Height 3 ¼? ? diameter 6?.
Adjustable 45 degree elbows are available for use in accommodating unusual offsets and configurations. These optional accessories are designed with the same end couplings as the straight sections in order to facilitate their use anywhere in the system.
The storm collar is used at the top of each flashing to assist in shedding water from the assembly. Inside diameter 3 5/8? - Outside diameter 6 ¾? ? Height 1 ¾?.
