Selkirk Ultra-Temp Type HT Chimney, in 6" diameter, is ideal for venting residential heating appliances burning natural and LP gas, #2 oil and wood. It has been specifically designed for today’s modern, high efficiency “airtight” wood stoves or as they are termed: solid fuel wood burning fireplaces. It is also suitable for wood-burning heaters and for combination fuel central heating furnaces.
Standard Stainless Steels are used for all insulated parts with Type 304 Stainless being used as the inner liner of the chimney. The smooth stainless steel inner liner produces rapid stabilization of strong draft and heats fast to minimize condensation as waste gases are exhausted. The insulation in the pipe assures the highest possible inner wall temperature by preventing circulation of air between inner and outer chimney walls. This special insulation filling the space between the stainless steel walls is only 1" thick, yet it provides 17 times the insulating value of brick.
Selkirk’s chimney can be easily installed by one man. The chimney sections have threaded internal couplers that lock together in seconds with a 1/8 turn. Locking Bands are furnished with every pipe length to assure complete joint security. These systems come with a variety of components to meet every installation requirement.
Selkirk Type HT chimneys have been tested to 2100°F. These high temperature tests comply with Underwriter’s Laboratories Safety Standard for Factory-Built Chimneys, UL-103 Sixth Edition.
Limited Lifetime Warranty
Refer to manufacturer’s instructions for proper installation, usage, and maintenance.
The Roof Support Kit includes the roof brackets and hardware only.
Works on all diameters of chimney. Allows freedom to install…
Used wherever a Ceiling Support, Finish Support, or Fire Stop is installed below an open attic. The Insulation shield is…
Includes two elbows, two locking bands and an interior re-support.
The 15 degree Insulated Elbow can be used for fixed offsets…
Includes two elbows, two locking bands and an interior resupport. Click picture for detailed description.
The 30 degree Insulated Elbow can…
Flashings are used to seal the opening where the chimney penetrates the roof to divert rain and snow down from…
The Anchor Plate provides a secure attachment for the chimney to smoke chamber outlet on masonry fireplaces, reducing footing loads…
For use in new installations, this part
can be installed by twist-locking the coupler on the DSAC into the first…
The Finish Ceiling Support (FSP), is finished in matte black and is available with a square trim plate. With proper…
Round collar fits over lower end of suspended insulated chimney pipe to provide finished appearance. Used to attach a DSA…
Part of the chimney system roof assembly, the Round Top is designed with a dome to exclude rain and leaves,…
For use in existing installations, this part can be installed into the first section of Platinum Series Type HT chimney…
A Roof Brace Kit can be used whenever there is a need to stabilize the chimney above the roof level.…
Used to support a vertical wall installation above the tee or above an offset. It can also serve as an…
Flashings are used to seal the opening where the chimney penetrates the roof and to divert rain and snow down…
This adapter is designed to be installed onto the end of a Selkirk Ultra Temp series chimney section before insertion…
The Insulated Chimney Tee may be used to start chimneys indoors or outdoors using a Wall Support assembly or a…
18" Chimney Section has an installed length of 16 3/4" and can be intermixed with various lengths to attain virtually…
36" Chimney Section has an installed length of 35 5/16" and can be intermixed with various lengths to attain virtually…
48" Chimney Section has an installed length of 47 5/16" and can be intermixed with various lengths to attain virtually…
6" Chimney Section has an installed length of 6" and can be intermixed with various lengths to attain virtually any…