Selkirk Ultra-Temp Type HT Chimney, in 6" diameter, is ideal for venting residential heating appliances burning natural and LP gas, #2 oil and wood. It has been specifically designed for today’s modern, high efficiency “airtight” wood stoves or as they are termed: solid fuel wood burning fireplaces. It is also suitable for wood-burning heaters and for combination fuel central heating furnaces.
Standard Stainless Steels are used for all insulated parts with Type 304 Stainless being used as the inner liner of the chimney. The smooth stainless steel inner liner produces rapid stabilization of strong draft and heats fast to minimize condensation as waste gases are exhausted. The insulation in the pipe assures the highest possible inner wall temperature by preventing circulation of air between inner and outer chimney walls. This special insulation filling the space between the stainless steel walls is only 1" thick, yet it provides 17 times the insulating value of brick.
Selkirk’s chimney can be easily installed by one man. The chimney sections have threaded internal couplers that lock together in seconds with a 1/8 turn. Locking Bands are furnished with every pipe length to assure complete joint security. These systems come with a variety of components to meet every installation requirement.
Selkirk Type HT chimneys have been tested to 2100°F. These high temperature tests comply with Underwriter’s Laboratories Safety Standard for Factory-Built Chimneys, UL-103 Sixth Edition.
Limited Lifetime Warranty
Refer to manufacturer’s instructions for proper installation, usage, and maintenance.
Used wherever a Ceiling Support, Finish Support, or Fire Stop is installed below an open attic. The Insulation shield is…
Includes two elbows, two locking bands and an interior re-support.
The 15 degree Insulated Elbow can be used for fixed offsets…
Includes two elbows, two locking bands and an interior resupport. Click picture for detailed description.
The 30 degree Insulated Elbow can…
Fits 2/12 to 6/12 pitch. Made with a very soft aluminum base that can be easily molded to fit uneven…
Flashings are used to seal the opening where the chimney penetrates the roof to divert rain and snow down from…
Flashings are used to seal the opening where the chimney penetrates the roof and to divert rain and snow down…
The Adjustable Pitched Ceiling Plate gives a finished appearance where the chimney passes through a sloped ceiling. Adjustable for various…
The Anchor Plate provides a secure attachment for the chimney to smoke chamber outlet on masonry fireplaces, reducing footing loads…
For use in new installations, this part can be installed by twist-locking the coupler on the DSAC into the first…
The Finish Ceiling Support (FSP-R), is finished in matte black and is available with a round trim plate. With proper…
The Finish Ceiling Support (FSP), is finished in matte black and is available with a square trim plate. With proper…
Round collar fits over lower end of suspended insulated chimney pipe to provide finished appearance. Used to attach a DSA…
For all ceiling joist penetrations which are present below the roof (other than that in which a ceiling support is…
Use to assure complete joint security. Allows chimney to be taken apart without damage to the joint so it can…
Joist shield for Mobile home installations.…
Insulated Tee Plug used to cover opening at bottom of tee. can be removed from bottom opening for inspection and…
Part of the chimney system roof assembly, the Round Top is designed with a dome to exclude rain and leaves,…
For use in existing installations, this part can be installed into the first section of Platinum Series Type HT chimney…
Made of flexible expanded 18-8 stainless steel mesh with diamond shaped openings roughly 1/2 x 1 inch. Pre-formed to slip…
The Storm Collar is designed to fit on the round chimney pipe just above the roof flashing. The upper edge…