The Rugged Stainless Steel Chimney That Makes Every Installation Simple, Fast And Sound.
Standard Stainless Steels are used for all insulated parts. The smooth stainless steel inner liner produces rapid stabilization of strong draft and heats fast to minimize condensation as waste gases are exhausted. The insulation in the pipe assures the highest possible inner wall temperature by preventing circulation of air between inner and outer chimney walls. This special insulation filling the space between the stainless steel walls is only 1" thick, yet it provides 17 times the insulating value of brick.
Selkirk’s chimney can be easily installed by one man. The chimney sections have threaded internal couplers that lock together in seconds with a 1/8 turn. Locking Bands are furnished with every pipe length to assure complete joint security. These systems come with a variety of components to meet every installation requirement.
Selkirk Type HT chimneys have been tested to 2100°F. These high temperature tests comply with Underwriter’s Laboratories Safety Standard for Factory-Built Chimneys, UL-103 Sixth Edition.
Limited Lifetime Warranty
Refer to manufacturer’s instructions for proper installation, usage, and maintenance.
This adapter is designed to be installed onto the end of a Selkirk Ultra Temp series chimney section before insertion…
Flashings are used to seal the opening where the chimney penetrates the roof to divert rain and snow down from…
Fits 2/12 to 6/12 pitch. Made with a very soft aluminum base that can be easily molded to fit uneven…
Used wherever a Ceiling Support, Finish Support, or Fire Stop is installed below an open attic. The Insulation shield is…
The Anchor Plate provides a secure attachment for the chimney to smoke chamber outlet on masonry fireplaces, reducing footing loads…
Part of the chimney system roof assembly, the Round Top is designed with a dome to exclude rain and leaves,…
For use in existing installations, this part can be installed into the first section of Platinum Series Type HT chimney…
For use in new installations, this part can be installed by twist-locking the coupler on the DSAC into the first…
Includes two elbows, two locking bands and an interior resupport.The 15 degree Insulated Elbow can be used for fixed offsets…
Includes two elbows, two locking bands and an interior resupport.The 30 degree Insulated Elbow can be used…
The Finishing Collar fits over lower end of suspended insulated chimney pipe to provide finished appearance. Used to attach T-DSA…
The Finish Ceiling Support (FSP), is finished in matte black and is available with a square trim plate. With proper…
The Finish Ceiling Support (FSP-R), is finished in matte black and is available with a round trim plate. With proper…
Insulated Tee plug used to cover opening at bottom of tee. can be removed from bottom opening for inspection and…
The Insulated Chimney Tee may be used to start chimneys indoors or outdoors using a Wall Support assembly or a…
The Insulated Wall Thimble installs quickly and eliminates the need for using individual firestops. The round shielding acts as a…
Used in floor/ceiling penetrations other than those which include a ceiling support. Not required when passing through roof.…
Use to assure complete joint security. Allows chimney to be taken apart without damage to the joint so it can…
Used in mobile home installations to provide shielding.…